毕业设计

110kV区域变电站电气部分设计

时间:2021-10-31 11:26:46   作者:未知   来源:网络文摘   阅读:391   评论:0
中文摘要
    变电站作为电力系统中的重要组成部分,直接影响整个电力系统的安全与经济运行。本论文中待设计的变电站是一座降压变电站,在系统中起着汇聚和分配电能的作用,担负着向该地区工厂、农村供电的重要任务。该变电站的建成,不仅增强了当地电网的网络结构,而且为当地的工农业生产提供了足够的电能,从而达到使本地区电网安全、可靠、经济地运行的目的。
    本论文《110kv变电站一次部分电气设计》,首先通过对原始资料的分析及根据变电站的总负荷选择主变压器,同时根据主接线的经济可靠、运行灵活的要求,选择了两种待选主接线方案进行了技术比较,淘汰较差的方案,确定了变电站电气主接线方案。
    其次进行短路电流计算,从三相短路计算中得到当短路发生在各电压等级的母线时,其短路稳态电流和冲击电流的值。再根据计算结果及各电压眉兜亩疃ǖ缪购妥畲蟪中工作电流进行主要电气设备选择及校验(包括断路器、隔离开关、电流互感器、电压互感器等)。
    最后,并绘制了电气主接线图、电气总平面布置图、防雷保护配置图等相关设计图纸。
关键词  电气主接线设计;短路电流计算;电气设备选择;设计图纸
Abstract
    Power system substation as an important part of the entire power system directly affects the safety and economic operation. To be designed in this paper is a step-down substation substation in the system plays the role of aggregation and distribution of electric energy, charged with the factory to the region, the important task of rural electrification. The completion of the substation will not only strengthen the local power grid network structure, but also for the local industrial and agricultural production provides enough power, so that the regional power grid so as to achieve safe, reliable and economic operation purposes.
    The paper "110kv substation once part of the electrical design," the first original data through the analysis and selection based on total load of the substation main transformer, the main wiring under both economical and reliable, flexible operation requirements, select the main connection of two programs to be selected A technical comparison, out of poor program to determine the main electrical substation connection program.
    Second, the short-circuit current calculation, obtained from the three-phase short circuit calculation occurs when short-circuit the voltage level of the bus, its steady-state current and the impact of short-circuit current value. According to the results and the voltage level of voltage and maximum continuous operating current of the main electrical equipment selection and validation (including circuit breaker, disconnecting switch, current transformer, voltage transformer, etc.).
Finally, the main draw of the electrical wiring diagram, electrical general layout map, lightning protection and other related design layout plan drawings. 
Keywords   
    Electrical main wiring design; short-circuit current calculation; electrical equipment selection; design drawings
目  录
第1章 设计的内容和要求
1.1 原始资料分析
1.2 设计原则和基本要求
1.3 设计内容
第2章 主变压器的选择
2.1 主变台数的确定
2.2 本变电站站用变压器的选择
2.3 小结
第3章 电气主接线的选择
3.1 选择原则
3.1.1 主接线设计的基本要求及原则
3.1.2 主接线的基本形式和特点
3.2 变电站的各侧主接线方案的拟定
3.3 小结
第4章 短路电流计算
4.1 短路计算的目的及假设
4.2 短路电流计算的步骤
4.3 短路电流计算及计算结果
4.4 小结
第5章 导体和电气设备的选择
5.1 电气设备的选择原则
5.2 断路器和隔离开关的选择
5.3 互感器的选择
5.4 母线的选择
5.5 高压熔断器的选择
5.6 消弧线圈的选择
5.7 小结
第6章 变电站防雷保护及其配置
6.1 直击雷的过电压保护
6.2 雷电侵入波的过电压保护
6.3 避雷器和避雷线的配置
6.4 小结
第7章 高压配电装置及平面布置
7.1 设计原则与要求
7.2 高压配电装置
7.3 小结
结 论
参考文献
致 谢
附录1 骼渍氡;し段图
附录2 变电所总体平面布置图
附录3 110KV/35KV/10KV降压变电站电气一次主接线图
附件下载
该文章所属专题:机械毕业设计

相关评论
免责申明:我要玩起网旨在提供一个相互学习交流的平台,是一个完全免费的网站,部分原创作品,欢迎转载,部分内容来自互联网,如果侵犯了您的权利请尽快通知我们!邮箱:834308595@qq.com Copyright 2018-2021我要玩起网  湘ICP备17006802号-2